The engine control module (ECM), or powertrain control module (PCM) commands the fans ON in high speed or low speed. In low speed, the fans are configured in series. In high speed, the fans are configured in parallel.

In low speed operation, the ECM or PCM applies ground to the coil side of the low speed relay, which is Fan 1 Relay 33. Voltage is applied directly to the left cooling fan through the switch side of the low speed relay. The right fan is connected in series to the left fan through the de-energized Series/Parallel relay, which is Fan 3 Relay 32, so that both fans operate at low speed.

In high speed operation, the ECM or PCM applies a ground to the coil side of the low speed relay, the Series/Parallel relay, and the high speed relay, which is relay Fan 2 Relay 31. Voltage is applied directly to the right cooling fan through the switch side of the high speed relay. The left cooling fan obtains voltage through the low speed relay and ground through the Series/Parallel relay.

When the ECM or PCM is commanding a fan relay ON, the voltage of the control circuit should be low, near 0 volts. When the ECM or PCM is commanding a fan relay OFF, the voltage of the control circuit should be high, near battery voltage.

Schematic Reference

Engine Cooling Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Cooling Fan Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. If DTCs P0480 or P0481 are set, then perform those diagnostics first.
2. Verify with a scan tool that the ECM or PCM is not commanding fan relay activation.
3. Ignition ON, command each relay ON and OFF with a scan tool. Observe to verify that the fan turns ON and OFF with each command.

Important: You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.

1. Ignition OFF, disconnect the Series/Parallel relay, which is fan 3 relay 32.
2. Ignition ON, activate the Cooling Fan Relay 1 with a scan tool. The fan should be OFF.

⇒	If the fan is activated, test the left fan ground circuit for a short to ground.

3. Ignition OFF, disconnect the remaining relays.
4. Install a 30A fused jumper between the normally-open switch contact terminals 86 and 87 at the Series/Parallel relay connector in order to complete the fan ground circuit. Leave this jumper in place for the remainder of this procedure.
5. One at a time, connect a 30A fused jumper between the positive terminal at the battery and the fan voltage supply circuit terminal 87 at the Fan 1 Relay 33, which is low speed fan relay, and the Fan 2 Relay, which is high speed fan relay, connections and verify fan activation.

⇒	If the appropriate fan does not activate, test the fan voltage supply circuit for a short to ground or open/high resistance. If the circuit tests normal, test the fan ground circuit for an open/high resistance. If the circuits test normal, replace the fan.

6. Ignition ON, connect a 30A fused jumper between the relay switch voltage supply circuit terminal 86 and the fan voltage supply circuit terminal 87 at the low speed and high speed fan relay connections and verify fan activation.

⇒	If the fan does not activate, test the relay switch voltage supply circuit for a short to ground or an open/high resistance. If the circuit tests normal and its fuse is open, test all connected components and replace as necessary.

7. If the circuits and fans test normal, replace the relay.

Ignition ON, command the relay ON and OFF with a scan tool. Observe to verify that the fan turns ON and OFF with each command.