Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0895 00: Device VoltageDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ | C0895 00 | C0895 00 | -- | -- |
Ground | -- | C0895 00 | -- | -- |
Circuit/System Description
Voltage is supplied to the electronic suspension control (ESC) module in the battery positive voltage circuit. The ESC module monitors the supplied voltage to determine if it is within a valid operating range.
Conditions for Running the DTC
Ignition is ON.
Conditions for Setting the DTC
The DTC is set when the battery voltage is outside the normal range of 9-15.5 V.
Action Taken When the DTC Sets
| • | The electronic suspension control system (ECS) is disabled for the duration of the ignition cycle. |
| • | The DIC displays the Service Stability System message, if equipped. |
Conditions for Clearing the DTC
The DTC is saved as history when the ESC module no longer sees battery voltage outside the normal range of 9-15.5 V.
Diagnostic Aids
| • | A low voltage DTC in multiple modules indicates a concern in the charging system. |
| • | DTC C0895 may set when the vehicle is placed on a battery charger, on fast charge, for a long period of time. It may also be set by an intermittent charging system malfunction. |
Reference Information
Schematic Reference
Electronic Suspension Control Schematics
Connector End View Reference
Description and Operation
Electronic Suspension Control Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information.
Circuit/System Verification
- Engine running measure and record the voltage at the battery terminals. Verify that the battery voltage is 12.6-15.5 V.
- Observe the scan tool ESC Battery Positive Voltage parameter. The reading should be between 12.6 and 15.0 V.
| ⇒ | If the battery voltage is not within the specified range, refer to Charging System Test. |
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the ESC module.
- Ignition OFF, test for less than 3 Ω between the ground circuit terminal 2 and ground.
- Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 1 and ground
- If all circuits test normal, replace the ESC module.
| ⇒ | If greater than the specified range, test the ground circuit for an open/high resistance. |
| ⇒ | If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ESC module replacement, setup and programming
