Exhaust Manifold Rear Pipe Replacement LD8

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the muffler to rear exhaust manifold pipe nuts.
3. Position the exhaust system rearward, enough to allow the studs located in the muffler to clear the rear exhaust manifold pipe.
4. Remove and discard the muffler to rear exhaust manifold pipe gasket.



5. Remove the rear exhaust manifold pipe to the right exhaust manifold bolts.
6. Remove the rear exhaust manifold pipe to the front exhaust manifold pipe bolts.
7. Remove and discard the rear exhaust manifold pipe gasket.
8. Remove and discard the rear exhaust manifold pipe seal.
9. Remove the rear exhaust manifold pipe flange.

Caution: When inspecting or replacing exhaust system components, make sure there is adequate clearance from all points on the underbody to prevent overheating of the floor pan and possible damage to the passenger compartment insulation and trim materials.

1. Install the following components to the rear exhaust manifold pipe.

1.1.	Position a NEW rear exhaust manifold pipe seal and the rear exhaust manifold pipe flange to the rear exhaust manifold pipe.

1.2.	Insert and snug the 2 rear exhaust manifold pipe to flange bolts.

1.3.	Insert the 2 rear exhaust manifold pipe to exhaust manifold bolts.

1.4.	Place a NEW rear exhaust manifold pipe to exhaust manifold gasket onto the bolts.

2. Install and position the rear exhaust manifold pipe to the front exhaust manifold pipe and exhaust manifold.

Caution: Refer to Fastener Caution in the Preface section.

3. Tighten the rear exhaust manifold pipe to exhaust manifold bolts to 40 N·m (30 lb ft).
4. Tighten the rear exhaust manifold pipe to front exhaust manifold pipe bolts to 25 N·m (18 lb ft).



5. Place a NEW muffler to rear exhaust manifold pipe gasket over the muffler studs.
6. Position the muffler to the rear exhaust manifold pipe.
7. Install the muffler to rear exhaust manifold pipe nuts and tighten to 25 N·m (18 lb ft).
8. Lower the vehicle.