GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2009 🢒 Lucerne 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Evaporative Emission Canister Replacement

Removal Procedure

Note: A service replacement evaporative emission (EVAP) canister will come with a EVAP canister filter, but will NOT come with a EVAP canister vent solenoid valve. The valve will have to be transferred from the old canister.


    Object Number: 1671749 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Disconnect the chassis EVAP pipe quick connect fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
  3. Disconnect the fuel tank vapor line quick connect fitting (3) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
  4. Disconnect the fuel fill pipe vent line quick connect fitting (2) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
  5. Remove the EVAP canister nuts.

    6. Object Number: 1672202 Size: SH
  6. Lower the EVAP canister until the EVAP canister vent solenoid valve electrical connector can be disconnected.
  7. Disconnect the rear body harness electrical connector from the EVAP canister vent solenoid.

    8. Object Number: 1672201 Size: SH
  8. Remove the EVAP canister.

    9. Object Number: 1672169 Size: SH
  9. Place the EVAP canister on a suitable work surface.
  10. Rotate the EVAP canister vent solenoid valve counterclockwise.

    11. Object Number: 1672170 Size: SH
  11. Remove the EVAP canister vent solenoid valve.

Installation Procedure

    Object Number: 1672170 Size: SH
  1. Install the EVAP canister vent solenoid valve to the new canister.

    2. Object Number: 1672169 Size: SH
  2. Rotate the EVAP canister vent solenoid valve clockwise until the solenoid valve comes to a stop in the retainer.

    3. Object Number: 1672202 Size: SH
  3. Place the EVAP canister near the underbody.
  4. Connect the rear body harness electrical connector to the EVAP canister vent solenoid.

    5. Object Number: 1672201 Size: SH
  5. Install the EVAP canister onto the studs.

    6. Caution: Refer to Fastener Caution in the Preface section.

  6. Install the EVAP canister nuts.

    7. Tighten
    Tighten the nuts to 6 N·m (53 lb in).


    Object Number: 1671749 Size: SH
  7. Connect the fuel fill pipe vent line quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
  8. Connect the fuel tank vapor line quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
  9. Connect the chassis EVAP pipe quick connect fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
  10. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.