Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1016 47: Vehicle Identification Number (VIN) Information Not ProgrammedCircuit/System Description
When the ignition is turned ON, the vehicle direction alert alarm warning (VDAAW) module receives the vehicle identification number (VIN) from the body control module (BCM). The VDAAW module will compare the VIN received to the VIN stored in memory.
Conditions for Running the DTC
Ignition ON
Conditions for Setting the DTC
There is no stored VIN in the VDAAW module.
Action Taken When the DTC Sets
| • | Lane departure warning is disabled |
| • | SERVICE LANE DEPARTURE SYSTEM is displayed on the DIC. |
Conditions for Clearing
| • | The DTC will transition to history when a valid VIN is stored in the VDAAW module. |
| • | A history DTC will clear after 100 malfunction-free ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Object Detection Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Important: Do not install a module which has been previously installed in another vehicle or otherwise swap modules between vehicles. Swapping modules between vehicles will cause DTC B1016 to set.
Verify that DTC B1016 is not set.
Important: When programming the VDAAW, use a Tech 2 and Candi module. Using the MDI to program the VDAAW will result in a failure to complete the programming operation.
| ⇒ | If the DTC is set, perform the Vehicle Direction Alert Alarm Warning Module Programming and Setup procedure. If the DTC resets, replace the VDAAW module. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for VDAAW module replacement, setup, and programming
