Warning: Refer to Brake Dust Warning in the Preface section.

Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.

1

Guide Pin Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Note: Install an open end wrench to hold the caliper guide pin in line with the caliper while removing or installing the caliper guide pin bolt. DO NOT allow the open end wrench to come in contact with the brake caliper.

Tip

Tighten
34 N·m (25 lb ft)

2

Guide Pin (Qty: 2)

Tip
Apply a small amount of high temperature silicone brake lubricate to the inside of the guide pin seal.

3

Guide Pin Seal

Tip
Ensure the lip of the seal is fully seated in the groove of the guide pin and the caliper bracket.