Removal Procedure
- Remove the case side cover. Refer to
Control Valve Body Cover Replacement.
- Disconnect the transaxle wiring harness.
- Remove the control valve body bolts (375 and 381) that mount the fluid pressure manual valve position switch to the control valve body (300).
- Carefully remove the fluid pressure manual valve position switch. Handle the switch carefully, the fluid pressure manual valve position switch is very delicate.
- Inspect the fluid pressure manual valve position switch (395) for the following conditions:
| • | Damaged electrical connector terminals |
| • | Damaged switch membranes |
| • | Debris on the switch membranes |
Installation Procedure
- Carefully install the fluid pressure manual valve position switch. Handle the switch carefully, the fluid pressure manual valve position switch is very delicate.
Caution: Refer to Fastener Caution in the Preface section.
- Install the control valve body bolts (375 and 381) that mount the fluid pressure manual valve position switch to the control valve body (300).
Tighten
| • | Tighten the control valve body bolt (375) to 12 N·m (106 lb in). |
| • | Tighten the control valve body bolt (381) to 8 N·m (70 lb in). |
- Connect the transaxle wiring harness.
- Install the case side cover. Refer to
Control Valve Body Cover Replacement.
Note: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
- Reset the TAP values. Refer to
Transmission Adaptive Functions.
