Special Tools

1. Remove the transaxle. Refer to Transmission Replacement.
2. Install the J 44214 to the engine block.



3. Loosen the flywheel bolts.
4. Remove all but one of the flywheel bolts, leaving the one bolt at the top of the crankshaft.
5. Grasp the engine flywheel with one hand and remove the remaining bolt. Do not drop the engine flywheel when removing the final bolt.
6. Clean and inspect the engine flywheel. Refer to Engine Flywheel Cleaning and Inspection.

1. Apply sealant to the flywheel bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers.
2. Place the engine flywheel in position against the crankshaft.

Caution: Refer to Fastener Caution in the Preface section.

3. Install the flywheel bolts.

Tighten

•	Tighten the bolts a first pass to 30 N·m (22 lb ft).

•	Tighten the bolts a final pass an additional 50 degrees using the J 45059 .




4. Remove the J 44214 from the engine block.
5. Install the transaxle. Refer to Transmission Replacement.