Preliminary Procedures

1. Remove the ignition and start switch. Refer to Ignition and Start Switch Replacement.
2. If equipped with AN3, disconnect the park lock cable. Refer to Transmission Control Replacement.
3. Remove the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement.
4. Remove the turn signal cancel cam and steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement.

1

Ignition Lock Cylinder Case Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
7 N·m (62 lb in)

2

Ignition Lock Cylinder Case