Preliminary Procedures

1. Remove the right front wheelhouse panel liner. Refer to Front Wheelhouse Liner Replacement.
2. Remove the washer pump hose from the pump and drain the washer solvent into a suitable clean container.
3. Disconnect the electrical connector from the windshield washer solvent level sensor switch and washer pump.

1

Windshield Washer Container Assembly Nuts (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tip
Tighten the nuts in sequence as shown.

Tighten
6 N·m (53 lb in)

2

Windshield Washer Container Assembly Nut

Tip
Tighten the nut in sequence as shown.

Tighten
6 N·m (53 lb in)

3

Windshield Washer Solvent Hose

4

Windshield Washer Solvent Hose Retainer Clips

Tip
Ensure the washer hose retainer clips are secure to the lower inner wheelhouse panel and strut tower.

5

Windshield Washer Solvent Container Assembly

Tip
Ensure the mounting tabs are flush to the rail by holding the container firmly against the rail and finger tighten the nuts upon assembly.