Tools Required

1. Disconnect the negative battery cable.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

2. Remove the serpentine belt(s) from the crankshaft pulley.
3. Raise the vehicle on a hoist.
4. Remove the right front wheel and tire assembly.
5. Remove the right inner fender access cover.
6. Hold the flywheel with J 37096 Flywheel Holding Tool.
7. Using 28 mm socket, remove the crankshaft harmonic balancer retaining bolt.
8. Remove the crankshaft harmonic balancer using special tool J 38197 Balancer Remover.
9. Disconnect the electrical connector from the camshaft position sensor.



10. Remove the camshaft position sensor retaining screw.
11. Remove the Camshaft Position (CMP) sensor from the engine front cover.

1. Install the camshaft position sensor to the engine front cover.



2. Install the camshaft position sensor retaining bolt.

Tighten:
Tighten the bolt to 5 N·m (44 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Connect the camshaft position sensor electrical connector.
4. Position the crankshaft harmonic balancer on the crankshaft.
5. Hold the flywheel with J 37096 Flywheel Holding Tool.

Tighten
Using J 36660 Torque/Angle Meter, tighten the harmonic balancer bolt to 150  N·m +76 degrees (110 lb ft +76 degrees).

6. Install the right inner fender access cover.
7. Install the right front wheel and tire assembly.

Tighten
Tighten the wheel nuts to 140  N·m (104 lb ft).

8. Lower the vehicle.
9. Install the serpentine belt(s).
10. Connect the negative battery cable.