Removal Procedure
- Disconnect the negative battery cable.
- Disconnect the electrical connector from the camshaft position sensor.
- Remove the camshaft position sensor retaining screw.
- Remove the Camshaft Position (CMP) sensor from the engine front cover.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the camshaft position sensor to the engine front cover.
- Install the camshaft position sensor retaining bolt.
- Connect the camshaft position sensor electrical connector.
- Connect the negative battery cable.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten:
Tighten the bolt to 5 N·m (44 lb in).
