Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Disconnect the harness connector from the wiper motor.
2. Turn the ignition to ON.
3. Set the wiper switch to LO.
4. Connect a test light from the wiper motor connector (harness side), terminal H, to ground.

Is the test light on?

--

Go to Step 6

Go to Step 3

Check for an open or a poor connection in CKT 477.

Is an open or a poor connection present?

--

Go to Step 4

Go to Step 5

Repair the open or the poor connection in CKT 477.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

1. Turn the ignition off.
2. Remove the wiper motor cover. Refer to Wiper Motor Cover Replacement .
3. Connect a jumper from the wiper motor terminal (opposite the wiper cover terminal marked T3) to ground.
4. Connect a fused jumper (10 amp) from the wiper motor terminal (opposite the wiper cover terminal marked T2) to battery voltage.

Is the wiper motor operating?

--

Go to Step 7

Go to Step 4

Replace the wiper motor. Refer to Windshield Wiper Motor Replacement .

Is replacement complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--