Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Open the negative battery cable transition block cable protector cover.
2. Open the positive battery cable transition block cable protector cover.



3. Disconnect the negative battery cable from the negative battery cable transition block.
4. Disconnect the positive battery cable from the positive battery cable transition block.
5. Disconnect the positive battery cable from the positive battery terminal on the underhood junction block.



6. Disconnect the positive battery cable wire ties from tie down locations.
7. Disconnect the positive battery cable from the starter.
8. Remove the positive battery cable from the vehicle.

1. Install the positive battery cable into the vehicle and lay the cable into its approximate location.
2. Connect the positive battery cable to the starter. Refer to specifications.
3. Lay the positive cable into its original routing location and connect all wire ties.



4. Connect the positive battery cable to the positive battery transition block.
5. Connect the positive battery cable to the positive battery terminal on the underhood junction block.
6. Connect the negative battery cable to the negative battery cable transition block.



7. Close the positive battery cable transition block cable protector cover.
8. Close the negative battery cable transition block cable protector cover.