Removal Procedure
- Remove the left sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel Gauges and Console.
- Remove the headlamp auto
controller connector (3).
- Remove the lower retainer bracket from the headlamp auto controller
module bracket.
- Squeeze the prongs together to release the headlamp auto controller
module.
- Remove the headlamp auto controller module from the mounting bracket
by pulling down on the headlamp auto controller module.
Installation Procedure
- Install the headlamp auto
controller module on to the bracket by sliding the module upward and slightly
rearward into the mounting bracket.
Slide the module into position until the locking tabs engage.
- Install the lower retainer bracket to the headlamp auto controller
module bracket.
Engage the headlamp auto controller module center prongs into the module
bracket center area.
- Connect the headlamp auto controller electrical connections (3).
- Install the left sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel Gauges and Console.