Refer to
Cell 120: Front Power Window Components
.
Circuit Description
The simple bus interface, CKT 217 (LT BLU), provides a communications path from both the passenger door module (PDM) and rear door module (RDM) and the driver door module (DDM). The DDM contains the following two types of software:
| • | Switch message decoding software |
| • | Simple bus interface diagnostic software |
The software enables the DDM to monitor the state of the passenger door power window switch.
Conditions for Setting the DTC
DTC B2202 sets any time one of the power window switches is continuously closed in either the UP or DOWN position for a period of greater than 15 seconds.
DTCs B1982 (battery Voltage High) and B1983 (Battery Voltage Low) must not be current or the diagnostic will not run.
Action Taken When the DTC Sets
The switch command will be ignored until it again changes state or the ignition cycles from OFF to RUN.
Conditions for Clearing the MIL/DTC
| • | This DTC will set from current to history when the window up input cycles off or when the power mode changes from OFF to RUN. |
| • | The history DTC will clear after 50 ignition cycles. |
| • | Use a scan tool in order to clear a history DTC. |
Diagnostic Aids
| • | A history DTC is evidence of an intermittent condition. |
| • | If DTC B2203 is current, cycle the ignition switch from OFF to RUN. If this DTC is still current, perform the following diagnostic procedure. |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
Perform the Power Door Diagnostic System Check prior to continuing the diagnosis of this DTC.
-
This step tests for other current DTCs.
-
This step inspects the RH front door lock actuator.
-
This step tests CKT 501 for a short to ground.
Step | Action | Value(s) | Yes | No | ||||
|---|---|---|---|---|---|---|---|---|
Was the Power Door Diagnostic System Check performed? | -- | Go to Step 2 | ||||||
Inspect the scan tool for the following DTCs:
Are both of the DTCs stored current? | -- | Go to Step 5 | Go to Step 3 | |||||
Is the RH front door lock actuator stuck in the open position or in the closed position? | -- | Go to Step 6 | Go to Step 4 | |||||
4 | Test CKT 501 (BRN) for a short to ground. Did you find a short to ground? | -- | Go to Step 7 | Go to Step 6 | ||||
Replace the PDM. Refer to Front Door Module Replacement . Is the repair complete? | -- | Go to Step 8 | -- | |||||
6 | Replace the RH front power window switch. Refer to Front Side Door Window Switch Replacement . Is the repair complete? | -- | Go to Step 8 | -- | ||||
7 | Repair the short to ground in CKT 501 (BRN). Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 8 | -- | ||||
8 |
Are all the DTCs cleared? | -- | -- |
