The circuit for the LH rear power window consists of the following components:
• | The LH rear power window switch. |
• | The rear door module (RDM). |
• | The simple bus interface (SBI). |
• | The driver door module (DDM). |
The LH rear power window switch provides input to the RDM. The RDM contains a software program that samples the window switch and reports all switch activity as SBI messages to the DDM. The actual diagnostic software program for DTC B2205 is contained in the DDM. The diagnostic program is run at least once every 300 milliseconds. Faults involving the DDM or the SBI may set other DTCs and affect the operation of the power door locks and the outside rearview mirrors.
DTC B2205 is set current if the SBI messages from the RDM indicate that the LH rear power window switch has been in the DOWN position for 15 consecutive seconds. This diagnostic will not run if either DTC B1982 (battery voltage high) or DTC B1983 (battery voltage low) are current.
This DTC is current only when the fault is present. While DTC B2205 is current the RDM ignores actuation of the LH rear power window switch.
• | This DTC is changed form current to history when the window DOWN input cycles off or when the power mode changes from OFF to RUN. |
• | The history DTC clears after 50 ignition cycles. |
• | Use a scan tool in order to clear a history DTC. |
• | A history DTC is evidence of an intermittent problem. |
• | When DTC B2205 is current, cycle the ignition switch from OFF to RUN. If the DTC is still present, perform the following diagnostic procedure. |
The number(s) below refer to the step number(s) on the diagnostic table.
Perform the power door diagnostic system check prior to diagnosing DTC B2205.
This tests step checks for other current set DTCs.
This step verifies the operation of the rear door power window switches.
This step tests CKT 1187 for a short to ground.
Step | Action | Value(s) | Yes | No |
---|---|---|---|---|
Did you perform the Power Door Diagnostic System Check? | -- | Go to Step 2 | ||
Are both of the DTCs B2203 and B2205, or B2206 and B2207 set current? | -- | Go to Step 5 | Go to Step 3 | |
Is one of the rear door window switches stuck in the up position or in the down position? | -- | Go to Step 6 | Go to step 4 | |
Test CKT 1187 (YEL) for a short to ground. Is the circuit OK? | -- | Go to Step 6 | Go to Step 7 | |
5 | Replace the rear door module (RDM). Refer to Door Control Module Replacement . Is the repair complete? | -- | Go to Step 8 | -- |
6 | Replace the LH rear power window switch. Refer to Cigarette Lighter and Side Window Switch Replacement . Is the repair complete? | -- | Go to Step 8 | -- |
7 | Repair the short to ground in CKT 1187 (YEL). Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to step 8 | -- |
8 |
Are all the DTCs cleared? | -- | -- |