Removal Procedure
- Remove the door handle
bezel (3).
- Remove the armrest cover plate (5).
- Remove the 2 fasteners (4) from the armrest.
- Remove the courtesy lamp assembly (2).
- Remove the fastener from behind the lamp assembly.
- Remove the power window switch trim plate. Refer to
Cigarette Lighter and Side Window Switch Replacement
.
- Lift up on the trim panel in order to disengage the hooks on
the backside of the panel (1).
- Disconnect the electrical connector.
- Remove the trim panel.
Installation Procedure
- Partially install the trim panel.
- Connect the electrical
connectors.
- Install the door trim panel by engaging the hooks on the backside
of the panel (1).
- Ensure the door trim panel is fully seated prior to fastener installation.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the fastener
behind the lamp assembly.
Tighten
Tighten the fastener to 0.6N·m (5 lb in).
- Install the courtesy lamp assembly (2).
- Install the 2 fasteners (4) in the armrest.
Tighten
Tighten the two fasteners to 0.6 N·m (5 lb in).
- Install the armrest cover plate (5).
- Install the door handle bezel (3).
- Install the power window switch plate. Refer to
Cigarette Lighter and Side Window Switch Replacement
.