Did you perform the Heated Seats System Check?

--

Go to Step 2

Go to Heated Seats System Check

1. Disconnect the appropriate heated seat switch connector.
2. Connect a fused jumper from the battery positive voltage (B+) to the appropriate heated seat switch connector cavity:

•	LH: cavity A (DK BLU)

•	RH: cavity A (DK BLU/WHT)

3. Connect a fused jumper from the heated seat switch connector cavity E (BLK) to ground.

Does the high heat LED light?

--

Go to Step 3

Go to Step 5

1. Disconnect the appropriate heated seat module connector 
2. Connect a J 39200 (DMM) between the appropriate components:

•	LH: the heated seat module connector C1 cavity F (DK BLU) and the heated seat switch connector cavity A (DK BLU)

•	RH: the heated seat module connector C1 cavity F (DK BLU/WHT) and the heated seat switch connector cavity A (DK BLU/WHT)

Is the resistance less than the specified value?

5 ohms

Go to Step 4

Go to Step 6

Replace the suspect heated seat module. Refer to Heater Module Replacement .

Is the repair complete?

--

Go to Step 7

--

Replace the suspect heated seat switch.

Is the repair complete?

--

Go to Step 7

--

Repair the open in the appropriate circuit between the heated seat module and the heated seat switch:

Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Step 7

--

Perform the Heated Seats System Check. Refer to Heated Seats System Check .

Was the Heated Seats System Check performed?

--

System OK

--