Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you
perform the
Fuel Filler Door Release System Check
?
| --
| Go to
Step 2
| Go to
Fuel Filler Door Release System Check
|
2
| Pull the manual release on the fuel door release actuator .
Does the fuel door open?
| --
| Go to
Step 4
| Go to
Step 3
|
3
| Replace the fuel door. Refer to
Fuel Tank Filler Door Replacement
.
Is the repair complete?
| --
| Go to
Step 15
| --
|
4
|
- Disconnect the fuel door release actuator connector.
- Connect J 39200
digital multimeter (DMM) between connector terminal B and ground.
Is the measured voltage within the specified range?
| 10-15V
| Go to
Step 6
| Go to
Step 5
|
5
| Check the TRUNK REL fuse.
Is the fuse OK?
| --
| Go to
Step 13
| Go to
Step 14
|
6
|
- Connect a DMM between the fuel door release actuator connector
terminals A and B.
- Depress the fuel door release switch.
Is the measured voltage within the specified range?
| 10-15V
| Go to
Step 7
| Go to
Step 8
|
7
|
- Check the fuel door release actuator connector for poor terminal
contact.
- If OK, replace the fuel door release actuator. Refer to
Fuel Tank Filler Door Lock Actuator Replacement
.
Is the repair complete?
| --
| Go to
Step 15
| --
|
8
|
- Disconnect the fuel door release switch connector.
- Use a DMM to measure the resistance between switch connector terminal B
and ground.
Is the resistance within the specified range?
| Less than 5ohms
| Go to
Step 10
| Go to
Step 9
|
9
| Repair the open in CKT 450 (BLK) between the fuel
door release switch and ground G201.
Is the repair complete?
| --
| Go to
Step 15
| --
|
10
|
- Connect a fused jumper across the fuel door release switch connector
terminals A and B.
- Use a DMM to measure the resistance between the fuel door release
actuator connector terminal A and ground.
Is the resistance within the specified range?
| Less than 5ohms
| Go to
Step 11
| Go to
Step 12
|
11
|
- Check the fuel door release switch connector for poor terminal
contact.
- If OK, replace the fuel door release switch. Refer to
Fuel/Rear Compartment Release Switch Replacement
in Instrument Panel, Gauges and Console.
Is the repair complete?
| --
| Go to
Step 15
| --
|
12
| Repair CKT 79 (PNK)
Is the repair complete?
| --
| Go to
Step 15
| --
|
13
| Repair the open in CKT 1140 (ORN).
Is the repair complete?
| --
| Go to
Step 15
| --
|
14
|
- Repair the short to ground in CKT 1140 (ORN).
- Replace the TRUNK REL fuse.
Is the repair complete?
| --
| Go to
Step 15
| --
|
15
|
- Make sure any components removed during diagnosis are installed
in place and that all connectors are connected.
- Repeat the system check. Refer to
Fuel Filler Door Release System Check
.
Is the system check complete?
| --
| System OK
| --
|
