The LH front power door lock switch feeds switch signals to the LH front power window switch over CKT 780 (RED/BLK) and CKT 781 (ORN/BLK). The LH front power window switch converts the switch inputs to serial digital data and broadcasts the message out on the simple bus interface. The simple bus interface, CKT 217 (LT BLU), provides a communications path from the driver' s door switch to the driver's door module (DDM). The DDM contains the following two types of software:
• | Switch message decoding software |
• | Simple bus interface diagnostic software |
The software enables the DDM to accept messages from the door switch and test the interface between the two components.
• | If either of the switch inputs for LOCK or UNLOCK remain closed continuously for 30 seconds, DTC B2221 sets. |
• | DTCs B1982 (Battery Voltage High) and B1983 (Battery Voltage Low) must not be current or the diagnostic will not run. |
The switch actuation will be ignored until the switch leaves the low state change of the lock switch input. The manual door lock levers and key locks will still function normally.
• | This DTC will set from current to history when the UNLOCK input cycles off or when the power mode changes from OFF to RUN. |
• | The history DTC will clear after 50 ignition cycles. |
• | Use a scan tool in order to clear the history DTC. |
The scan tool can be selected to monitor DDM inputs and set outputs as well as view DTCs. The scan tool may also used to select remote function actuator (RFA) inputs, outputs and options.
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Value(s) | Yes | No |
---|---|---|---|---|
Has the Power Door Diagnostic System Check been performed? | -- | Go to Step 2 | ||
Is the LH Front Power Door Lock Switch mechanically stuck in the lock or unlock position? | -- | Go to Step 5 | Go to Step 3 | |
Go to DDM inputs. Does the LH Front Door Lock Switch display lock or unlock? | -- | Go to Step 4 | Go to Step 6 | |
Connect a DMM across the power door lock switch terminals B and C. Move the door lock switch to the LOCK position. Is the resistance within the specified range for both switch positions? | 0-5 ohms | Go to Step 7 | Go to Step 5 | |
5 | Replace the LH Front Power Door Lock Switch. Refer to Door Lock Switch Replacement . Is the repair complete? | -- | Go to Step 10 | -- |
6 | Replace the DDM. Refer to Front Door Module Replacement . Is the repair complete? | -- | Go to Step 10 | -- |
Test CKT 781 (ORN/BLK) for a short to ground. Is the circuit OK? | -- | Go to Step 9 | Go to Step 8 | |
8 | Repair the short to ground in CKT 781 (ORN/BLK) Refer to Wiring Repairs in wiring Systems. Is the repair complete? | -- | Go to Step 10 | -- |
9 | Replace the LH Front Power window Switch. Refer to Front Side Door Window Switch Replacement Is the repair complete? | -- | Go to Step 10 | -- |
10 |
Are all the DTCs cleared? | -- | -- |