Refer to
Cell 133: PASS-Key® III
Circuit Description
The theft deterrent (VTD) module performs an internal test to determine if a valid key is present every 300 milliseconds. If the test determines that a invalid key is present the VTD module will indicate a invalid coded key is current.
Conditions for Setting the DTC
At the beginning of the ignition cycle the VTD module detects a invalid coded key.
Action Taken When the DTC Sets
| • | Stores a DTC B2960 in the VTD module memory. |
| • | Security indicator is illuminated. |
Conditions for Clearing the DTC
| • | The VTD module detects a valid coded key. |
| • | The history DTC will clear after 50 ignition cycles. |
| • | Use a scan tool in order to clear a history DTC. |
Diagnostic Aids
Check all vehicle ignition keys and inspect the invalid key(s) for damage.
Test Description
The numbers below refer to the step numbers on the diagnostic table:
-
Perform the Theft Deterrent Diagnostic System Check before continuing with the diagnosis of this DTC.
-
Clear all DTCs and cycle ignition to check that the DTC did not falsely set.
-
Clear all DTCs after the repair procedure is complete.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Was the Theft Deterrent Diagnostic System Check performed? | -- | Go to Step 2 | ||
Is the DTC still present? | -- | Go to Step 3 | ||
3 | Replace the VTD Module. Refer to Theft Deterrent Module Replacement . Refer to Programming Theft Deterrent System Components . Is the replacement complete? | -- | Go to Step 4 | -- |
Are all DTCs cleared? | -- | -- |
