GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2000 🢒 Park Avenue 🢒 Brakes 🢒 Hydraulic Brakes 🢒 Master Cylinder Overhaul
  1. Remove the master cylinder. Refer to Master Cylinder Replacement .
  2. Clamp the master cylinder into vise by one of the mounting ears (15).
  3. Remove the master cylinder reservoir. Refer to Master Cylinder Reservoir Replacement .

    4. Object Number: 474733 Size: SH

    Notice: Use care not to damage the piston bore or retainer groove during primary piston retainer ring removal.

  4. Remove the retainer (8) while depressing the primary piston assembly (9)
  5. Plug the outlet port closest to the rear of the master cylinder.

    6. Caution: Wear safety glasses when using compressed air in order to prevent eye injury.

    Caution: If air pressure is used to remove the secondary piston, place the open end of the cylinder bore approximately 25 mm (1 in) from a padded workbench or other surface to catch the piston when it comes out of the bore. Apply low air pressure very carefully to ease the piston out of the bore. Never point the open end of the bore at anyone when applying air pressure. The piston may come out of the bore with considerable force and cause personal injury.

  6. Apply low pressure, non-lubricated compressed air into the outlet port (secondary) at the front end of the cylinder.
  7. Remove the following parts:
    8. 7.1. Primary piston assembly (9)
    7.2. Primary seal (10)
    7.3. Secondary piston (13)
    7.4. Secondary seal (12)
    7.5. Spring retainer (11) and spring (14)

    Notice: Use only approved solvents when cleaning or flushing the master cylinder and related components. Solvents which contain traces of mineral oil or other contaminants will damage the rubber parts in the system.

  8. Inspect the master cylinder bore for scoring or corrosion. If any damage is present replace the master cylinder assembly.
  9. Clean all parts with denatured alcohol.
  10. Dry with non-lubricated compressed air.
  11. Lubricate all parts with new Delco Supreme 11® (GM P/N 12377967), or equivalent DOT-3 brake fluid.
  12. Install the secondary spring and piston assembly into the bore (14,11,12,13,10).
  13. Install the primary piston assembly (9) and depress enough to install the retainer (8).
  14. Install the master cylinder reservoir. Refer to Master Cylinder Reservoir Replacement .
  15. Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding .
  16. Install the master cylinder. Refer to Master Cylinder Replacement .