Parking Brake Cable Replacement Front Cable

1. Remove the left closeout / insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges, and Console.
2. Remove the left front carpet retainer.



3. Pull the edge of the drivers side carpet back far enough to access the grommet.
4. Remove the grommet from the floor pan.
5. Raise the vehicle and support. Refer to Lifting and Jacking the Vehicle in General Information.



6. Disconnect the front cable housing (2) from the intermediate cable (1) at the cable clip.
7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
8. Disconnect the cable from the lever assembly.
9. Remove the parking brake front cable assembly.

1. Position the front parking brake cable assembly in the vehicle.
2. Connect the cable to the lever assembly.
3. Raise the vehicle and support. Refer to Lifting and Jacking the Vehicle in General Information.



4. Connect the front cable housing (2) to the intermediate cable (1) at the cable clip.
5. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



6. Seat the grommet in the floor pan.
7. Install carpet into place.
8. Install the left closeout / insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges, and Console.
9. Adjust the parking brake cable. Refer to Park Brake Cable Service/Adjustment .

Parking Brake Cable Replacement Intermediate Cable

1. Raise the vehicle and support. Refer to Lifting and Jacking the Vehicle in General Information.
2. Disconnect the intermediate parking brake cable (1) from the cable clip (2).
3. Disconnect intermediate cable housing from the cable retaining bracket.



4. Disconnect the intermediate cable (3) from the rear equalizer (1).
5. Disconnect the intermediate cable housing from the rear cable housing retaining bracket.
6. Remove the intermediate cable.

1. Route and install the intermediate parking cable into brake cable retaining brackets.
2. Connect the left (2) and right (5) rear parking brake cables to the intermediate cable (3), using equalizer (1).



3. Insert the intermediate cable (1) into the cable retaining bracket and lock the cable into place.
4. Connect front of the intermediate cable (1) to the front cable using the connecting clip.
5. Adjust the parking brake cable. Refer to Park Brake Cable Service/Adjustment .

Parking Brake Cable Replacement Rear Cables

1. Raise the vehicle and suitably support. Refer to Lifting and Jacking the Vehicle in General Information.
2. Back off the adjuster nut to release cable tension.
3. Disconnect the right (5) and the left (2) rear parking brake cables from the rear equalizer (1).
4. Remove the conduit fitting from the bracket by depressing the conduit fitting retaining tangs.
5. Remove the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.



6. Remove the right and the left cable retainer bolts (3).



7. Disconnect the right and left parking brake cables from the parking brake levers.
8. Remove the right and left cable from the caliper support brackets by depressing the conduit fitting retaining tangs.
9. Remove the parking brake rear cables (1).

1. Position the right (5) and the left (2) rear parking brake cable to the vehicle.
2. Install the conduit fitting to the bracket by snapping the bractet into place.
3. Connect the cables to the equalizer (1).



4. Install the right and the left cable retainer bolts (3).



5. Install the right and the left cables to the caliper support brackets by snapping the brackets into place.
6. Connect the parking brake cables (1) to the parking brake levers.
7. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tire and Wheel.
8. Adjust the parking brake cable. Refer to Park Brake Cable Service/Adjustment .