Step | Action | Yes | No |
|---|---|---|---|
1 | Did you review the Steering Wheel and Column Description and Operation and perform the necessary inspections? | Go to Step 2 | |
2 | Verify that the lock system sticks in the START position. Does the lock system operate normally? | System OK | Go to Step 3 |
3 | Inspect the ignition lock cylinder case assembly for damage. Is the ignition lock cylinder case assembly damaged? | Go to Step 6 | Go to Step 4 |
4 | Inspect the lock cylinder for damage. Is the lock cylinder damaged? | Go to Step 7 | Go to Step 5 |
5 | Inspect the ignition switch for damage. Is the ignition switch damaged? | Go to Step 8 | Go to Step 3 |
6 |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems. Tighten the ignition lock cylinder case assembly mounting bolts. Refer to Fastener Tightening Specifications . Did you complete the repair? | Go to Step 9 | -- |
7 | Replace the lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle . Did you complete the repair? | Go to Step 9 | -- |
8 | Replace the ignition switch. Refer to Ignition Switch Replacement - On Vehicle . Did you complete the repair? | Go to Step 9 | -- |
9 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
