Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.
- Remove the steering wheel from the column. Refer to
Steering Wheel Replacement
.
- Remove the tilt lever from the lower trim cover. Refer to
Tilt Lever Replacement
.
- Remove the 2 pan head tapping screws (1, 2)
from the lower trim cover (3).
- Gently unsnap the lower trim cover from
the upper trim cover.
Important: In order to remove the upper trim cover and lock cylinder you will need
to release the lock cylinder retaining pin in the access hole of the ignition
lock cylinder case.
- Remove 1 TORX® head screw (1) from the upper trim
cover (2).
- Remove the ignition lock cylinder. Refer to
Ignition Lock Cylinder Replacement
.
- Remove the upper trim cover.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the upper trim cover (2) onto the steering column. Install
1 TORX® head screw (1) into the upper trim cover (2).
Tighten
Tighten the screw to 1.5 N·m (13 lb in).
- Install the lower trim cover onto the
upper trim cover.
Important: If column shift, the shift lever seal must be seated in the trim covers.
- Slide the shift lever seal down the shift lever.
- Gently snap the upper and lower trim covers together.
- Install 2 pan head
tapping screws (1, 2) into the lower trim cover (3).
Tighten
• | Tighten 1 pan head tapping screw (1) to 3.5 N·m
(31 lb in). |
• | Tighten 1 pan head tapping screw (2) to 2 N·m
(18 lb in). |
- Install the ignition lock cylinder. Refer to
Ignition Lock Cylinder Replacement
.
- Install the tilt lever into the lower trim cover. Refer to
Tilt Lever Replacement
.
- Install the steering wheel onto the steering column. Refer to
Steering Wheel Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
in
SIR.