GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2003 🢒 Park Avenue 🢒 HVAC 🢒 Heating, Ventilation and Air Conditioning 🢒 Air Temperature Door Replacement - Right Side

Removal Procedure
  1. Remove the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
  2. Remove the mode actuator.
  3. Remove the recirculation actuator.
  4. Remove the right temperature actuator.
  5. Remove the left temperature actuator.
  6. Remove the fasteners that retain the mode actuator bracket.
  7. Remove the mode actuator bracket.
  8. Remove the upper HVAC module case screws.

    9. Object Number: 292114 Size: SH
  9. Peel back the foam seal at the heater inlet.

    10. Object Number: 688088 Size: SH
  10. Remove the upper HVAC module case half.

    11. Object Number: 688103 Size: SH
  11. Remove the right temperature door.

Installation Procedure

    Object Number: 688103 Size: SH
  1. Install the right temperature door.

    2. Object Number: 688088 Size: SH
  2. Install the upper module case.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the module case screws.

    4. Tighten
    Tighten the screws to 1.4 N·m (12 lb in).


    Object Number: 292114 Size: SH
  4. Reapply the foam seal at the heater inlet.
  5. Install the mode actuator and bracket.

    6. Tighten
    Tighten the screws to 1.4 N·m (12 lb in).

  6. Install the left temperature actuator.

    7. Tighten
    Tighten the screws to 1.4 N·m (12 lb in).

  7. Install the right temperature actuator.

    8. Tighten
    Tighten the screws to 1.4 N·m (12 lb in).

  8. Install the recirculation actuator.

    9. Tighten
    Tighten the screws to 1.4 N·m (12 lb in).

  9. Install the HVAC module assembly. Refer to HVAC Module Assembly Replacement .