GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2003 🢒 Park Avenue 🢒 HVAC 🢒 HVAC Systems - Automatic 🢒 Duct Air Temperature Sensor Replacement - Upper Right Side

Removal Procedure

    Object Number: 262503 Size: SH
  1. Pull outward to disengage the retainers of the IP outer trim covers.
  2. Remove the left IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Left Side in Instrument Panel Gages and Console.
  3. Remove the right IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side in Instrument Panel Gages and Console.
  4. Remove the left IP trim panel. Refer to Instrument Panel Trim Panel Replacement - Left Side in Instrument Panel Gages and Console.

    5. Important: It is not necessary to completely remove the lower IP trim.

  5. In order to access the duct screws, remove the upper fasteners retaining the lower IP trim.

    6. Object Number: 799933 Size: SH
  6. Pull the IP trim off the studs and lower the trim out of the way.

    7. Object Number: 799928 Size: SH
  7. Remove the two screws (1) at the center of the air distributor duct.

    8. Object Number: 799927 Size: SH
  8. Remove the screw at the outboard side of the air distributor duct and pull the duct off the stud.

    9. Object Number: 799925 Size: SH
  9. Remove the right air temperature sensor from the air distributor duct by turning counter-clockwise 1/4 turn.
  10. Disconnect the air temperature sensor electrical connector.

Installation Procedure

    Object Number: 799925 Size: SH
  1. Connect the air temperature sensor electrical connector to the sensor.
  2. Install the right air temperature sensor into the air distributor duct and turn the sensor clockwise 1/4 turn.

    3. Object Number: 799927 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the air distributor duct to the stud and install the outboard screw.

    4. Tighten
    Tighten the screw to 2 N·m (17 lb in).


    Object Number: 799928 Size: SH
  4. Install the air distributor duct center screws (1).

    5. Tighten
    Tighten the screws to 2 N·m (17 lb in).


    Object Number: 799933 Size: SH
  5. Align the lower IP trim to the studs and install the fasteners.

    6. Tighten
    Tighten the fasteners to 10 N·m (89 lb in).

  6. Install the left IP trim panel. Refer to Instrument Panel Trim Panel Replacement - Left Side in Instrument Panel Gages and Console.
  7. Install the right IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side in Instrument Panel Gages and Console.
  8. Install the left IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Left Side in Instrument Panel Gages and Console.

    9. Object Number: 262503 Size: SH
  9. Install the outer IP trim covers.