1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
2. Open and lower the instrument panel compartment by carefully releasing the rear holding tabs.



3. Pull down in order to remove the instrument panel module (IPM)  (1).
4. Disconnect the electrical connectors from the IPM.

Important: After the IPM is replaced, recalibrate the actuators for proper travel. Turn ON the ignition for 3 minutes to recalibrate the IPM and the actuators for proper travel.

1. Connect the electrical connectors to the IPM.



2. Install the IPM  (1) into the retainer on the bracket (2).
3. Close the instrument panel compartment.
4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.