Circuit Description
The body control module (BCM) controls the courtesy lamps theater dimming. The ground will slowly reduce in order to turn the lamps to the OFF position. If there is an open or a short to ground condition in the courtesy lamp low control circuit, DTC B2452 will set.
Conditions for Setting the DTC
The BCM detects a short to ground or an open in the courtesy lamp low control circuit.
Action Taken When the DTC Sets
| • | Stores DTC B2452 in the BCM memory. |
| • | No driver warning message will be displayed for this DTC. |
Conditions for Clearing the DTC
| • | The short to ground condition is no longer detected by the BCM in the courtesy lamp low control circuit. |
| • | The open circuit condition is no longer detected by the BCM in the courtesy lamp low control circuit. |
| • | The ignition key is cycled OFF and ON. |
| • | A history DTC clears after 50 consecutive ignition cycles if the condition for the fault is no longer present. |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Interior Lights Schematics Connector End View Reference: Master Electrical Component List in Wiring Systems | |||
1 | Did you perform the Lighting System Diagnostic System Check ? | Go to Step 2 | |
Test the courtesy lamp low control circuit of the body control module (BCM) for a short to ground or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 5 | Go to Step 3 | |
3 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 5 | Go to Step 4 |
4 |
Important:: Perform the setup procedure for the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System. Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Did you complete the replacement? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 2 | System OK |
