Tools Required

J 28733-B Front Hub Spindle Remover

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Clean the drive axle threads of all dirt. Lubricate the threads.



4. Insert a drift punch or a screwdriver into the caliper and the rotor in order to prevent the rotor from turning.
5. Remove the drive axle nut.
6. Remove the brake rotor. Refer to Front Brake Rotor Replacement in Disc Brakes.



7. Disconnect the ABS front wheel speed sensor connector. Unclip the connector from the dust shield.



8. Remove the wheel bearing/hub retaining bolts.

Important: Replace the hub and bearing only as an assembly.

9. Remove the wheel bearing/hub from the steering knuckle.
10. Remove the dust shield.
11. Use the J 28733-B in order to separate the hub and bearing from the drive axle.
12. Clean the rust and the foreign material from the following components in order to allow proper seating of the bearing into the knuckle:

•	The knuckle mounting face

•

The bore

•	The chamber

1. Remove the protective plastic cover before installation. Do not handle the knuckle or hub assembly by the ABS sensor wire.
2. Carefully install the dust shield. Do not damage the bearing outboard lip seal, or the hub and bearing bolts.
3. Apply a thin layer of grease to the steering knuckle bore.
4. Install the wheel bearing/hub and dust shield to the steering knuckle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the wheel bearing/hub retaining bolts.

Tighten
Tighten the wheel bearing/hub retaining bolts to 95 N·m (70 lb ft).




6. Install the new drive axle nut, draw wheel bearing/hub onto the axle.



7. Connect the ABS front wheel speed sensor connector. Clip the connector to the dust shield.
8. Install the brake rotor. Refer to Front Brake Rotor Replacement in Disc Brakes.



9. Insert a drift punch or a screwdriver into the caliper and rotor in order to prevent the rotor from turning.

Tighten
Tighten the drive axle nut to 160 N·m (118 lb ft).

10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
11. Lower the vehicle.