Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Support the engine assembly with a suitable jack.
- Remove the nut securing the right engine mount to the right engine mount bracket.
- Lower the jack allowing the engine to lower slightly.
- Remove the bolt (4) securing the mount to the body frame rail.
- Remove the two nuts (2) securing the mount to the body frame rail.
- Remove the right engine mount (3).
Installation Procedure
- Position the right engine mount (3) to the body frame rail.
- Install the mount attaching bolt (4) and nut (1) to the body frame rail.
- Install the two nuts (2) securing the right engine mount to the body frame rail.
- Raise the engine into position.
- Install the nut securing the right engine mount to the right engine mount bracket.
- Remove the engine support jack.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the right engine mount to body frame rail nuts (1, 2)
to 70 N·m (52 lb ft).
Tighten
Tighten the right engine mount nut to 80 N·m (59 lb ft).
