GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 39363 Supercharger Locknut Wrench

Removal Procedure

  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.
  2. Disconnect the vacuum hoses from the bypass valve actuator.
  3. Remove the boost control solenoid. Refer to Boost Control Solenoid Replacement .

  4. Object Number: 21728  Size: SH
  5. Remove the bypass valve actuator mounting bolts and rotate the bypass valve actuator until the rod disengages the lever.

Installation Procedure


    Object Number: 21738  Size: SH
  1. Install tool J 39363 onto actuator.
  2. Important: When installing the bypass valve actuator to the supercharger, be sure to rotate the assembly until the bypass valve shaft lever comes in contact with the stop block.

  3. Rotate the actuator until the rod engages the lever.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the bypass valve actuator mounting bolts.
  6. Tighten
    Tighten the bolts to 25 N·m (18 lb ft).

  7. Remove J 39363 .
  8. Install the boost control solenoid. Refer to Boost Control Solenoid Replacement .
  9. Connect the vacuum hoses to the bypass valve actuator.
  10. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.