Schematic Reference: Instrument Cluster Schematics

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Install a scan tool.
2. Raise the vehicle's drive wheels. Refer to Lifting and Jacking the Vehicle in General Information.
3. Start the engine.
4. Place the transmission into drive.
5. With the scan tool, observe the Vehicle Speed Sensor parameter in the PCM Engine Data 1 data list.

Does the Vehicle Speed Sensor parameter match the speedometer display?

--

Go to Step 3

Go to Step 4

Does the odometer operate properly?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 8

4

1. Turn the ignition OFF.
2. Disconnect the powertrain control module (PCM) connector C1.
3. Turn the ignition ON.
4. Measure the voltage from the vehicle speed signal circuit to a good ground.

Does the voltage measure greater than the specified value?

9.0 V

Go to Step 6

Go to Step 5

Test the vehicle speed signal circuit for a short to ground, or high resistance, or for open between the instrument panel cluster (IPC) and the PCM. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 8

Test the vehicle speed signal circuit for a short to battery voltage between the IPC and the PCM. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 7

Inspect for poor connections at the harness connector of the PCM. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 9

Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 10

Important: Program the replacement PCM.

Replace the PCM. Refer to Powertrain Control Module Replacement in Engine Controls.

Did you complete the replacement?

--

Go to Step 11

--

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

--

Go to Step 11

--

Operate the system in order to verify the repair.

Use the scan tool in order to clear the DTC's that may have set in other modules during diagnosis.

Did you correct the condition?

--

System OK

Go to Step 2