Removal Procedure
- Remove the right I/P cluster trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side.
- Remove the fasteners (2) that secure the HVAC control module.
- Pull the HVAC control module (1) rearward.
- Disconnect the HVAC control module electrical connectors.
Installation Procedure
- Connect the electrical connectors to the HVAC control module.
- Install the HVAC control module (1).
- Install the HVAC control module fasteners (2).
- Install the right I/P cluster trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side.
- Start the engine and let run for one minute.
- Refer to Control Module References for programming and setup information.
Important: The ignition must be in the OFF position when connecting the electrical connectors to ensure proper actuator calibration.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 1.8 N·m (16 lb in).
Important: Do not adjust any controls on the HVAC control module while the HVAC control module is self-calibrating. If interrupted improper HVAC performance will result.
The engine must be running for proper calibration to occur.