GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2005 🢒 Rainier 🢒 Body 🢒 Exterior Trim 🢒 Endgate Window Reveal Molding Replacement

Removal Procedure

    Object Number: 1204239 Size: SH
  1. Remove the rear wiper arm. Refer to Rear Window Wiper Arm Replacement .
  2. Remove the screws (2) retaining the endgate window reveal molding assembly (1) to the endgate.
  3. Slide the molding assembly rearward, then upward to release the molding retainers from the endgate.
  4. Disconnect the electrical connector for the high mounted stop lamp.
  5. Remove the high mounted stop lamp from the molding. Refer to High Mount Stop Lamp Replacement .

Installation Procedure

    Object Number: 1204239 Size: SH
  1. Install the high mounted stop lamp to the endgate window reveal molding (1). Refer to High Mount Stop Lamp Replacement .
  2. Connect the electrical connector for the high mounted stop lamp.
  3. Install the molding assembly to the endgate by inserting the retainers to the slots in the endgate panel and sliding the molding forward.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the screws (2) retaining the molding to the endgate.

    5. Tighten
    Tighten the molding screws to 3 N·m (27 lb in).

  5. Install the rear wiper arm. Refer to Rear Window Wiper Arm Replacement .