Cruise Control Indicator Inoperative. Buick Rainier - 2WD 2005

GM Service Manual Online

For 1990-2009 cars only

Makes 🢒 Buick 🢒 2005 🢒 Rainier - 2WD 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Cruise Control Indicator Inoperative

Cruise Control Indicator Inoperative non 4.2L

Step	Action	Yes	No
Schematic Reference: Cruise Control Schematics Connector End View Reference: Engine Control Module Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn OFF the ignition. Install a scan tool. Turn ON the ignition, with the engine OFF. With the scan tool, Command the Cruise Control Lamp Test parameter ON, in the instrument panel cluster (IPC) output controls. Does the Cruise indicator illuminate in the IPC?	Go to Step 3	Go to Step 4
3	Inspect for poor connections at the harness connector of the engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 6
4	Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 5
5	Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 7	--
6	Replace the ECM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 7	--
7	Operate the system in order to verify the repair. Does the system operate properly?	System OK	Go to Step 2

Cruise Control Indicator Inoperative 4.2L

Step	Action	Yes	No
Schematic Reference: Cruise Control Schematics Connector End View Reference: Powertrain Control Module Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn OFF the ignition. Install a scan tool. Turn ON the ignition, with the engine OFF. With the scan tool, Command the Cruise Control Lamp Test parameter ON, in the instrument panel cluster (IPC) Output Controls. Does the Cruise indicator illuminate in the IPC?	Go to Step 3	Go to Step 4
3	Inspect for poor connections at the harness connector of the powertrain control module (PCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 6
4	Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 5
5	Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 7	--
6	Replace the PCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 7	--
7	Operate the system in order to verify the repair. Does the system operate properly?	System OK	Go to Step 2