GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2005 🢒 Rainier - 2WD 🢒 Body 🢒 Instrument Panel, Gages, and Console 🢒 Instrument Panel Accessory Trim Plate Replacement - Left Side

Removal Procedure
  1. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  2. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .

    3. Object Number: 712835 Size: SH
  3. Remove the 2 headlamp trim plate retaining nuts.
  4. Use a plastic flat bladed tool in order to release the retaining clips.
  5. Remove the headlamp trim plate from the instrument panel (IP).

Installation Procedure

    Object Number: 712835 Size: SH
  1. Install the headlamp trim plate to the IP, ensuring the retaining clips are fully seated.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the 2 headlamp trim plate retaining screws.

    3. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  3. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  4. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .