Modules connected to the high and low speed GMLAN serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. The modules have prerecorded information about what messages are needed to be exchanged on the serial data circuits, for each virtual network. The messages are supervised and also, some periodic messages are used by the receiver module as an availability indication of the transmitter module. Each message contains the identification number of the transmitter module.
This diagnostic procedure supports the following DTC:
DTC U2105 Lost Communication With Engine Control Module (ECM)
This vehicle has DTCs which include DTC Symptoms. For more information on DTC Symptoms, refer to DTC Symptom Description .
DTC Symptom | DTC Symptom Descriptor |
---|---|
00 | No additional information |
• | Voltage supplied to the modules is in the normal operating voltage range. |
• | The vehicle power mode requires serial data communication to occur. |
• | The DTC U2100 does not have a current status. |
A supervised periodic message that includes the transmitter module availability has not been received.
The module uses a default value for the missing parameter.
• | A current DTC clears when the malfunction is no longer present. |
• | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
• | A poor connection at the inoperative module may cause this code to set. |
• | An improperly powered module may cause this code to set. |
Step | Action | Yes | No | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Data Link Connector Schematics or Control Module References Connector End View Reference: Master Electrical Component List | |||||||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |||||||||||
2 |
Important:: Use the DTC Descriptor list to determine the module which is not communicating. Test the following circuits of the module that is not communicating for an open or a short to ground:
Refer to the following:
Did you find and correct the condition? | Go to Step 7 | Go to Step 3 | ||||||||||
3 |
Did you find and correct the condition? | Go to Step 7 | Go to Step 4 | ||||||||||
4 | Test the high speed GMLAN serial data circuits of the module that is not communicating for an open. Refer to the following:
Did you find and correct the condition? | Go to Step 7 | Go to Step 5 | ||||||||||
5 | Test the following circuits of the module that is not communicating for poor connections:
Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 7 | Go to Step 6 | ||||||||||
6 | Replace the module that is not communicating. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 7 | -- | ||||||||||
7 |
Does the scan tool still display any other current DTCs? | System OK |