Some 1988-89 Rivieras and Reattas produced before the VIN breakpoints KH402818 and KB900906 may experience streaking or poor perfomance from the "wet-arm" windshield washer system. This may be caused by the volume of windshield washer solvent delivered to the wet-arm wiper blades. During operation of the washer system, solvent is delivered only on the up-sweep of the wiper blades. To repair this condition, a new washer control module (part number 22087513) which is currently available from GMSPO, delivers solvent on both the up and down sweep of the wiper blade. Graphite wiper blade inserts will also be available to improve wiper performance, part number 12337035.
Parts are currently available from GMSPO
The washer control module is contained within the windshield wiper motor cover and cannot be replaced independently. To replace the wiper motor cover:
1. Disconnect the electrical connector.
2. Remove cover screws.
3. Remove the wiper cover.
To install the wiper motor cover assembly:
1. Install wiper cover in position.
2. Install wiper cover screws.
3. Reconnect electrical connector.
WARRANTY INFORMATION
Labor Operation Number: N3750 Labor Time: .3 hours Trouble Code: 92
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.