1. Clean threads in the block using a 7/16-14 tap
2. Clean bolt threads using a wire brush
3. Cylinder head gasket on block
4. Apply sealant, GM part number 1052080, on bolt threads
5. Cylinder head bolts
6. Tighten cylinder head bolts to 47 N.m (35 lbs.ft.) in sequence
7. Rotate each bolt 130 deg. in sequence using J36660 Torque, Angle Meter.
8. Rotate the center four bolts an additional 30* in sequence using J36660, Torque Angle Meter.
9. Pushrods, guide plate and rocker arm assemblies
- Apply threadlock, GM part number 12345493, to rocker arm pedestal bolts before assembly
- Tighten rocker arm pedestal bolts to 38 N.m (28 lbs. ft.)
10. Intake manifold
11. Valve cover
12. Exhaust manifold:
- Front (left) cylinder head A/C compressor bracket bolt to 70 N.m (52 lbs. ft.) Generator support bracket to cylinder head Generator C3I and spark plug wires
- Rear (right) cylinder head Belt tensioner assembly Power steering pump Fuel line heat shield
13. Negative battery cable
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.