This bulletin has been revised to include part number for hex head screw and new sunshade support part numbers.
Some 1990 Reatta convertibles may experience a condition where the sun visor clips break during use. To repair this condition use the following procedure:
1. Operate the convertible top stack away from the front windshield header to the stowage compartment.
2. Remove three screws from sunshade mounting bracket. Rest sunshade on top of I/P.
3. Remove screw from sun visor clip.
4. Remove two screws from outboard edge of the windshield header centre moulding.
5. Remove one screw from the windshield upper garnish.
6. Pull down windshield garnish upper moulding to gain access to the hex head screw securing the sun visor clip. Remove hex head screw. If screw is lost or damaged, you must replace with P/N 12501103.
7. Remove sun visor clip and discard. Replace with the appropriate sun visor clip listed below:
Sunshade Support P/N ---------------- ------- Flame Red 3635185 Very Dark Sapphire 3635186 Medium Beechwood 3635187 Medium Slate Gray 3635188 Garnet Red 3635189
8. Reverse removal procedure for reinstallation.
9. Activate remote keyless entry transmitter to test for function.
Use the most applicable Labour Operation and Time from the Canadian Labour Time Guide.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.