WHEEL HUB/BEARING MOUNTING, BOLT TORQUE SPECIFICATIONS
Wheel hub/bearing mounting bolt torque should be changed to 70 N.m (52 lb. ft.).
Sections and pages affected are:
- FRONT SUSPENSION (SECTION 3C)
Page 3C-5, Step 1
Page 3C-6, Figure 11
Page 3C-13, Torque Specifications
- REAR SUSPENSION (SECTION 3D)
Page 3D-2, Step 2
Page 3D-11, Add to Torque Specifications
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.