ILLUMINATED LOCK CYLINDER AND LOCK ASSEMBLY

MODELS AFFECTED: 1989-90 REGALS

This bulletin is being issued to update replacement procedures for the illuminated lock cylinder and lamp assembly.

REMOVE OR DISCONNECT

Figures 1 and 2

1. Door handle cover assembly. Refer to DOORS (Section 10-5) in the Service Manual.

2. Lock cylinder to lock rod.

3. Screw securing lock cylinder to door.

4. Lock cylinder and spacer.

5. Theft deterrent shield.

6. Door trim panel. Refer to DOORS (Section 10-5) in the Service Manual.

7. Connector

8. Lamp assembly and harness from door.

Install or Connect

1. Lamp assembly and harness to door.

2. Connector.

3. Door trim panel. Refer to DOORS (Section 10-5) in the Service Manual.

4. Theft deterrent shield.

5. Spacer and lock cylinder.

6. Screw

- Tighten - Screw to 10 N.m (89 lb. in.)

7. Lock cylinder to lock rod.

8. Door handle cover assembly. Refer to DOORS (Section 10-5) in the Service Manual.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.