DIFFICULTY OPENING FRT. DOORS (WHEN USING INSIDE HANDLES)

SUBJECT: DIFFICULTY IN OPENING FRONT DOOR WHEN USING INSIDE HANDLES (SERVICE PROCEDURE)

MODELS AFFECTED: 1991-92 REGAL SEDANS

CONDITION:

---------- Some customers may comment about difficulty opening the front door on 1991 and 1992 Regal Sedans when using inside handles.

To check this condition, sit inside the vehicle and lock the door. Actuate the affected inside door handle, unlock the door and try to exit the vehicle. This may have to be done three or four times for the condition to occur. If the door will not open, follow the procedure below. The above condition may be reset by activating the outside door handle.

CAUSE:

------ Interference between the outside handle to lock rod and lever on the outside handle. See Figure 1.

CORRECTION:

----------- 1. Remove trim panel.

2. Remove water deflector.

3. Disengage retaining clip at lower end of the outside handle to lock rod and remove rod.

4. Remove two retaining nuts on outside handle and remove from door.

5. File radius as shown in Figure 2.

6. De-burr the inside edges of the handle where the rod fits through, sand all surfaces smooth that were filed.

7. Touch up all filed surfaces to stop corrosion. This will also ensure proper operation.

8. Reinstall door handle.

9. Reinstall outside handle to lock rod by adjusting nut on lower end of rod until knob of attaching nut is between one and two turns lower than the hole in the lever of the lock, snap nut into hole and engage clip onto lever and rod assembly.

10. Check for proper operation, reinstall water deflector and trim panel.

WARRANTY INFORMATION:

Labor Operation No.: T5284 Right Side T5285 Left Side Labor Time: .6 Hour Per Side

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.