1. Drain coolant. Refer to cooling and radiator.
2. Remove the air intake tube.
3. Remove the IAC valve, and TP sensor, electrical connectors.
4. Remove the accelerator control and cruise control cables from the accelerator control cable bracket.
5. Remove the accelerator control cable bracket.
6. Remove the throttle body coolant bypass hoses.
7. Remove the heater pipe nut at the throttle body.
8. Remove the nuts and bolts holding the throttle body to the intake manifold.
9. Remove the throttle body assembly.

Notice: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

1. Clean the gasket surface on the intake manifold and the throttle body assembly.
2. Install a new gasket, if necessary.
3. Install the throttle body assembly.
4. Install the throttle body retaining nuts and bolts (3).

Tighten
Tighten the throttle body retaining nuts and bolts to 25 N·m (19 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the heater pipe nut at the throttle body.
6. Install the throttle body coolant bypass hoses.
7. Install the IAC valve, and TP sensor, electrical connectors.
8. Install the accelerator control cable bracket.
9. Install the accelerator control and cruise control cables.
10. Install the PCV hose.
11. Install the air intake tube.
12. Refill the coolant. Refer to cooling and radiator.

Important: The throttle should operate freely without binding between full closed and wide open throttle.

13. Inspect and check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.