Tools Required

1. Remove the accessory drive belt. Refer to Drive Belt Replacement or Drive Belt Replacement in Engine Mechanical.
2. Remove the power steering pump. Refer to Power Steering Pump Replacement .
3. Use the J 25034-C with the J 37609 or the J 37609-A in order to remove the power steering pump pulley.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: 

•	The face of the pulley hub must be flush with the end of the pump driveshaft.

•	Do not use the arbor press to install the pulley.

1. Use the J 25033-C or the J 36015 in order to install the power steering pump pulley.



2. Install the power steering pump to the engine. Refer to Power Steering Pump Replacement .
3. Install the accessory drive belt. Refer to Drive Belt Replacement or Drive Belt Replacement in Engine Mechanical.
4. Fill the power steering system.Refer to Refilling the Power Steering System .
5. Bleed the power steering system.Refer to Power Steering System Bleeding .
6. Inspect the power steering system for leaks. Refer to Power Steering Gear and Pump Leaks .