For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Disconnect the 14-way connector from the ignition control module.
- Disconnect the spark plug wires from the coil assemblies (Noting the position that they were removed).
- Remove 6 screws (1) securing the coil assemblies to the ignition control module.
- Remove the coils (2) from the ignition control module (3).
- Remove the nuts and washers securing the ignition control module assembly to the mounting bracket.
- Remove the ignition control module from the module bracket.
Installation Procedure
- Attach the coils and the ignition control module to the module bracket. Refer to Ignition Coil Replacement .
- Install 6 ignition coil attaching screws
- Install the nuts and washers securing the ignition control module assembly to the mounting bracket.
- Connect the spark plug wires.
- Connect the 14-way connector to module.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 4-5 N·m (40 lb in).
Tighten
Tighten the nuts to 8 N·m (70 lb in).
