The instrument panel (IP) courtesy and the door courtesy lamps stay on under the following conditions:

However, the inadvertent load (battery rundown) protection turns off the courtesy lights after 20 minutes.

Has the Interior Light System Check been performed?

--

Go to Step 2

Refer to Interior Lamps System Check

Did you perform the Body Control module (BCM) Diagnostic System Check?

--

Go to Step 3

Refer to Diagnostic System Check - Body Control System

1. Ensure that the IP dimmer switch is off.
2. Close all of the vehicle doors.
3. Turn the ignition switch to the LOCK position.
4. Connect a Scan Tool .
5. Turn the ignition switch to the RUN position.
6. Use the Scan Tool to monitor the status of BATT PWR 3.

Does the Scan Tool display that the status of BATT PWR 3 is greater than 9V?

--

Go to Step 4

Go to Step 6

1. Disconnect then reconnect the BCM connector C2 and connector C3.
2. Turn the ignition switch to the RUN position.
3. Ensure that the IP dimmer switch is off.
4. Close all of the vehicle doors.
5. Observe the IP courtesy lamps and the door courtesy lamps.

Are the IP courtesy lamps and the door courtesy lamps off?

--

Go to Step 5

Go to Step 6

The malfunction is not present at this time. Refer to Interior Lights Circuit Description for more information regarding the operation of the courtesy lights.

Is the action complete?

--

Go to Step 7

--

1. Replace the BCM. Refer to Body Control Module Replacement in Body Control System.
2. Perform the Setup New BCM procedure. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.

Has the repair been made?

--

Go to Step 7

--

1. Turn the ignition switch to the LOCK position.
2. Reinstall the connectors and the components that you removed.

Have all the repairs been made?

--

Refer to Interior Lamps System Check

--