Circuit Description
The Body Control Module (BCM) receives the input from the Traction Control Switch. The BCM then sends a class 2 message to the EBTCM telling the EBTCM the state of the switch. The BCM supplies voltage to the TCS switch and when the TCS switch is depressed, the BCM sees the voltage go low and sends the EBTCM the message that the TCS switch state has changed. When the EBTCM receives the message from the BCM that the switch state has changed it turns on or off Traction Control and its TRAC OFF indicator depending on its previous state.
Diagnostic Aids
| • | It is very important that a thorough inspection of the wiring and connectors be performed. Failure to carefully and fully inspect wiring and connectors may result in misdiagnosis, causing part replacement with reappearance of the malfunction. |
| • | Thoroughly inspect any circuitry that may be causing the complaint for the following conditions: |
| - | Backed out terminals |
| - | Improper mating |
| - | Broken locks |
| - | Improperly formed or damaged terminals |
| - | Poor terminal-to-wiring connections |
| - | Physical damage to the wiring harness |
| • | The following conditions may cause an intermittent malfunction: |
| - | A poor connection |
| - | Rubbed-through wire insulation |
| - | A broken wire inside the insulation |
| • | If an intermittent malfunction exists refer to Intermittents and Poor Connections Diagnosis in Wiring Systems. |
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
DEFINITION: The TRAC OFF Indicator does not turn off after the Instrument Panel Cluster (IPC) bulb check or after the Traction Control Switch is pressed to turn the Traction Control on after it was disabled. | ||||
1 | Was the Diagnostic System Check performed? | -- | ||
2 |
Is DTC B2747 set in the Body Control Module? | -- | ||
3 |
Will the scan tool command the TRAC OFF indicator ON then OFF? | -- | ||
4 | Replace the EBCM/EBTCM. Refer to Electronic Brake Control Module/Electronic Brake and Track Control Module Replacement . Is the Replacement complete? | -- | -- | |
5 | Suspect the Instrument Panel Cluster. Refer to Diagnostic System Check - Instrument Cluster in Instrument Panel, Gauges and Console. Is the Replacement complete? | -- | -- | |
